Operation - Craftsman 247.887761 Manual Del Operador

Drive Control
blaDe COnTrOl
the blade control is attached to the upper handle of the mower. See
Figure 9. Depress and squeeze it against the upper handle to operate
the unit. Release it to stop engine and blade.
WarninG
this blade control is a safety device. Never attempt to bypass its
operations.
CUTTinG HeiGHT aDjUsTmenT
leVer
the cutting height adjustment lever is located above the
left rear wheel. to adjust the cutting height, refer to the
assembly section.
DriVe COnTrOl
the drive control is located on the upper handle. Squeeze the drive
control to engage the drive system. Release it to disengage the drive
system.
sHiFT leVer
the shift lever is located on the drive control housing on the upper
handle. this lever is used to select the forward speed of the mower.
when changing speed selection, release the drive control.
IMPORTANT: Move the shift lever only when the engine is running.
Changing the shift lever setting with the engine off can damage the
mower.

OPERATION

Shift Lever
Recoil Starter
Oil Cap/ Dipstick
Side Discharge Cover
Blade Control
Electric Start Ignition Key
Cutting Height
Adjustment Lever
Figure 9
eleCTriC sTarT iGniTiOn keY
the electric start ignition key is located on the left side of the handle
panel. It is used only for the electric starter.
siDe DisCHarGe COVer
your mower is shipped as a mulcher. to discharge the grass clippings
to the side instead, follow the instructions in the assembly section to
attach the side discharge cover.
Keep hands and feet away from the chute area on cutting deck. Refer
to warning label on the unit.
reCOil sTarTer
the recoil starter is connected to the support rod and is located on the
right side of the lower handle. Stand behind the unit and pull the recoil
starter rope to start the unit.
Gas CaP
Remove the gas cap to add fuel to the fuel tank. Use clean, fresh,
regular unleaded gasoline with a minimum of 87 octane.
Oil CaP/DiPsTiCk
Refer to the Maintenance section for instructions on checking the oil.
Trail sHielD
the trail shield is attached to the rear of the mower and is there to
protect the operator from flying debris. Do not use the mower unless
the shield is fully functional and in place.
13
Gas Cap
WarninG