Publicidad
Idiomas disponibles
Idiomas disponibles
Changing the tool.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
Mounting a grinding disc (figure 4).
Press the locking button only when the
motor is stopped.
Press the locking button fully through and
hold it in place. Loosen the quick-clamping
nut.
Unscrew the quick-clamping nut.
Replace the used-up grinding accessory
or insert a new one.
Pay attention that the grinding acces-
sory is properly centered between the
support flange and the quick-clamping
nut.
Fig. 4
2.
4.
1.
3.
Manually screw the quick-clamping nut on
again.
Press the locking button fully through and
hold it in place. Tighten the quick-clamping
nut.
Note:Observe the mounting direction of the
quick-clamping nut.
Offset grinding discs must be mounted in
such a manner that their grinding surface is
2 mm below the bottom edge the of the
wheel guard. Grinding accessories that do
not meet these requirements cannot be ade-
quately covered off and are not permitted.
2.
3.
en
1.
4.
17
Publicidad
