Fein CG13-150 Instrucciones De Uso página 20

en
20
Working instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respec-
tive application.
Switching on and off (figure 7).
Check the power supply
WARNING
cable and the plug for dam-
age.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
The soft start is used to reduce torque reac-
tion forces when switching on and running
up the power tool to the no-load speed.
The restarting protection prevents the
power tool from automatically restarting if
the power supply is interrupted during
operation. In this case, switch off the power
tool, check the power supply and then
switch the power tool on again.
The blocking monitor reduces the risk of
motor damage and the risk of accidents
when an application tool blocks. In this case,
the power tool switches off automatically.
Afterwards, set the switch to the off posi-
tion, remove the power tool from the
workpiece and check the application tool
for damage. Afterwards, switch the power
tool on again.
The electronic overload protection reduces
the risk of motor damage if the power tool
is overloaded. In this case, the power tool
switches off automatically. Afterwards, set
the switch to the off position, remove the
power tool from the workpiece and check
the application tool for damage. Afterwards,
switch the power tool on again.