How To Disassemble And Clean - HUROM H-310A Serie Manual De Instrucciones

9. How to Disassemble and Clean

12 12
After the product stops operating completely,
unplug the power cord with your dry hands. The
motor is still slowing down after the appliance
is turned off so wait about 3 seconds before
separating the chamber set.
01 Separate the chamber set from the product body.
Turn the hopper open and pull off the parts in order
to disassemble them.
02 Wash the parts with a cleaning brush under running
water.
03 Wash the chamber by opening the discharge cover
and the juice cap.
04 Wipe the product body with a damp towel or soft
cloth.
05 For silicon packings, remove and wash them after
use.
- Residue may remain stuck
(hopper packing, juice cap packing, extraction
packing, seal packing, screw packing).
06 You can sterilize the parts by soaking them in warm
water diluted with baking soda, citric acid or vinegar.
Failure to clean the product immediately after use can
cause its stainless steel parts and other parts to corrode or
become discolored due to salt and pulp from the ingredients.
Contaminants may dry out and get stuck inside, making it
difficult to disassemble or clean it, as well as adversely affect
its performance. Be sure to clean and air dry it completely after
use and store it in a clean place. For long-term storage, clean it
with the cleaning brush first. Do not clean it with boiling water
or subject it to high temperatures. Do not use abrasive cleaning
products or tools like kitchen sink cleaners or a stainless-steel
sponge. Do not put it in a dishwasher or dish dryer.