Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTIONS TO BE MADE
From the 22-pin Chrysler harness
• Connect the Yellow wire to the radio's 12-volt battery or memory wire.
• Connect the Black wire to the radio's ground wire.
• Connect the Blue wire to the radio's amp turn on wire if populated on the factory side.
For non-amplified vehicles (only), make the following connections:
• Disconnect the (2) 4-pin connectors, with the Purple and Green wires in it.
• Connect the 4-pin harness with stripped leads to the 4-pin connector, with the Purple and
Green wires, coming from the Gray 22-pin connector.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
• Connect the Purple wire to the radio's right rear positive speaker output.
• Connect the Purple/Black wire to the radio's right rear negative speaker output.
Tip: If you are unsure if your vehicle is amplified or not, note that these following wires will
only be populated in the factory harness if non-amplified.
• Connect the White wire to the left front positive speaker output of the aftermarket radio.
• Connect the White/Black wire to the left front negative speaker output of the aftermarket radio.
• Connect the Gray wire to the right front positive speaker output of the aftermarket radio.
• Connect the Gray/Black wire to the right front negative speaker output of the aftermarket.
(CONT.)
From the 12-way harness
• This harness is for the ASWC-1 (sold separately). Please refer to the ASWC-1 instructions for
programming.
• With all connections completed to the aftermarket radio, plug the 22-pin harness into the
vehicles wiring harness.
• Reconnect the negative battery terminal.
• Cycle the key, by turning the ignition on for 30 seconds. Then off and on again to test the radio.
• Turn the ignition on if not already, and then turn the radio on to verify that the radio works.
Check balance and fader controls for proper operation.
For amplified models only:
• To adjust the overall volume of your audio system rotate the potentiometer, which is located on
the 16-pin side of the interface clockwise.
CONNECTIONS TO BE MADE
INSTALLING THE CHTO-03
TESTING THE CHTO-03
(CONT.)
3
REV. 1/15/2018 INSTCHTO-03
Publicidad
