Publicidad
Idiomas disponibles
Idiomas disponibles
Front Wheels Assembly
1. Insert one of the front wheel assemblies into one opening
on the front of the base frame. Cover with the dust cap,
and fix with one set of the M8x20 screw + washer as shown
below. Use the wrench to rotate the screw clockwise to
secure. Place a cover cap on the top (Fig. 4).
Fig. 4
Cover cap
M8x20 screw
Washer
Dust cap
Wheel
assembly
2. Repeat for the other front wheel assembly.
Base Unit Assembly
1. Place the base frame with wheels on a stable ground. Insert
the battery compartment frame into the base frame as
shown below (Fig. 5).
Fig. 5
Battery compartment
frame
Base frame
2. Fix the assembly with 4 sets of hand knobs with short bolt
(Fig. 6).
Fig. 6
Battery
compartment
frame
Wrench
3. Insert the left handle into the left side of the battery
compartment frame, fix with a hand knob with long bolt
from the back and a hand knob with short bolt from the
side (Figs. 7 – 8).
NOTE: The height of the handles can be adjusted in 3
levels by aligning the hole on the battery compartment
frame with one of the 3 holes on the handle (Fig. 7). Make
sure the two handles are set in the same position.
Fig. 7
Align with different
holes for different
handle length
Fig. 8
4. Repeat the last operation to assemble the right handle.
5. Use the cable clips to clip the cables on the frame as
needed (Fig. 9).
11
Hand knob with
short bolt
Left Handle
Hand knob
with long bolt
Hand knob
with short bolt
Publicidad
