Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 9
Cable clips
Rear Wheel Frame Assembly
1. Insert the rear wheel frame into the base frame as shown
below (Fig. 10).
NOTE: The height of the rear wheel frame can be adjusted
in 3 levels by aligning the hole on the base frame with
one of the 3 holes on the rear wheel frame. Insert the
remaining 2 sets of handle knob with short bolt in the
aligned holes of the rear wheel frame and the base frame
as shown (Fig. 10).
Fig. 10
NOTE: When using the wheelbarrow on slope, it's
recommended to assemble the rear wheel frame by the
lower 2 holes, so the middle terrain wheel will always be
on the ground.
2. Secure the assembly by turning the hand knobs clockwise
firmly (Fig. 11).
Fig. 11
Cable clips
LED Headlights Assembly
1. Place one of the light assemblies on the inside of the base
frame, as shown. Align the biggest hole with the hole of
the base frame (Fig. 12).
Fig. 12
LED headlight
assembly
Hand knobs
with short
bolts
Rear wheel
frame
2. Secure the LED light assembly with a set of M6x16 screw
+ flat washer + spring washer. Use the hex wrench to turn
the screw clockwise tightly (Fig. 13).
Fig. 13
LED headlight
assembly
3. Repeat the above steps to assemble the other LED
headlight.
12
Tighten
the knobs
Rear wheel
frame
Align the holes
Hex wrench
M6x16 screw
Spring washer
Flat washer
Publicidad
