Publicidad
Idiomas disponibles
Idiomas disponibles
If a log does not split completely and becomes stuck on the wedge, follow the instructions
6. Important
below to remove the log.
STUCK LOG
A log can become stuck to the wedge if the wedge becomes embedded in the log and the
procedure
log doesn't split and separate. This can happen if the log is too stringy or tough to split
completely.
A stuck log will move back with the wedge on the initial attempt to retract the wedge. If
this happens, STOP retracting the wedge immediately and follow the directions below.
WARNING: NEVER attempt to remove a stuck log by:
• Using the hydraulic force of the splitter
• Modifying the splitter
• Adding attachments to the splitter
Personal injury could result from log or metal pieces flying out at high speed toward the
operator or bystanders, or the splitter could become damaged.
1. If there is already 1" or more of clearance between the log and endplate, go to step 2.
Otherwise, retract wedge just enough to remove pressure between the log and endplate
about 1" clearance. (Move split control to return, allow wedge to move about 1", then
stop the wedge by moving the split control to neutral "N".)
2. Turn engine OFF.
3. Remove stuck log from the wedge manually with a pry bar or a sledgehammer.
Important: Be extremely careful as log pieces may fly off as they separate from the
wedge. Make sure bystanders are clear and wear safety goggles.
4. Do not attempt to resplit a stuck log once it has been removed from the wedge.
Manually split with an axe, or cut with a chainsaw.
7. Return wedge
Move Split Control Lever away from endplate to return wedge. Once the control valve
is actuated in the return direction , the wedge is designed to keep returning by itself
completely and then stop automatically.
WARNING:
Stay clear while the wedge is returning. It is still powerful enough on the return stroke to
cause serious injury.
Splitting Operation
C ON TR OL VA LV E
OPE RAT IO N
N
FORWARD
BACKWARD
If the control valve is leaking,
Please replace the spare part, seal kit instead of the damaged one!
(Splitting Mode)
(Return Mode)
C ON TR OL VA LV E
OPE RAT IO N
N
FORWARD
BACKWARD
If the control valve is leaking,
Please replace the spare part, seal kit instead of the damaged one!
(Splitting Mode)
(Return Mode)
11
Publicidad
