Accessories; Environment; Troubleshooting; General Information - Festool CSC SYS 50 EBI Manual De Instrucciones

English

13 Accessories

Refer to the Festool catalogue for the order
numbers of accessories and tools or find them
online at www.festool.co.uk.

14 Environment

Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
Before disposal, users must remove discharged
batteries, accumulators that are not enclosed
by the device and lights that can be removed
from the old device without causing damage, if
these are present. The old batteries and re­
chargeable batteries can then be recycled sys­
tematically.
In accordance with the European Directive on
waste electrical and electronic equipment and
implementation in national law, used power
tools must be collected separately and handed
in for environmentally friendly recycling.
Information about collection points for correct
disposal is available at
recycling .
Information on REACH:
reach

16 Troubleshooting

Problem
The display does not
come on.
The display does not
show anything.
The display shows a
warning.
The display shows a
failure.
Status LED flashes red. Incorrect battery pack combi­
The Systainer hood
does not close.
40
www.festool.co.uk/
www.festool.co.uk/
Possible causes
One or both battery packs are
discharged.
Incorrect battery pack used.
Display fault.
Warning, e.g. due to over­
heating.
The power tool is attempting
to solve a problem, e.g. over­
heating.
The power tool is faulty.
nation inserted.
Undervoltage upon system
start (battery level too low).
Accessory parts are not in the
parked position.

15 General information

Imported into the UK by
Festool UK Ltd
1 Anglo Saxon Way
Bury St Edmunds
IP30 9XH
Great Britain
15.1 Bluetooth
®
The Bluetooth word mark and the logos are
®
registered trademarks of Bluetooth SIG, Inc.;
they are used by TTS Tooltechnic Systems AG &
Co. KG, and therefore by Festool, under licence.

15.2 Information on data privacy

The power tool contains a chip which automati­
cally stores machine and operating data. The
data saved cannot be traced back directly to an
individual.
The data can be read in a contactless manner
using special devices and shall only be used by
Festool for fault diagnosis, repair and warranty
processing and for quality improvement or en­
hancement of the power tool. The data shall not
be used in any other way without the express
consent of the customer.
Remedy
Charge the battery packs.
Use suitable battery packs (see section 4).
Contact an authorised service workshop or the
manufacturer.
Observe the info text in the dialogue box and ac­
knowledge the message via the focus line.
Follow the instructions on the display.
Contact an authorised service workshop or the
manufacturer.
See Section 4.
Replace the battery pack.
Move the power tool to the transport position
(see Section 11.1).