English; Introduction; Installation; Rear Panel - MasterWeld 200 AC/DC Manual De Instrucciones

ENGLISH

8

INTRODUCTION

200AC/DC is an inverter power source that can carry out
the following welding modes:
•
M
MA
•
C T
ONTINUOUS
•
P T welding with pulsed current at L
ULSED IG
frequency (slow pulsed TIG)
•
P T
ULSED IG
M frequency (fast pulsed TIG)
EDIUM
•
T A with square wave
IG C
In all types of TIG welding, it is possible to use the
following welding processes:
•
Two-stroke lift-arc (2
•
Four-stroke lift-arc (4
•
Two-stroke H (2
F
•
Four-stroke H
•
Four-stroke H
The generator has:
A front control panel with socket for remote controls.
A rear panel with gas supply connector, switch and
supply cable.
A positive (+) welding socket, a negative (-) welding
socket, a gas supply connector and a torch connector on
the front part.
THE MACHINE CAN ALSO BE CONNECTED TO
ENGINE-DRIVEN GENERATORS AS LONG AS THEY
HAVE A STABILIZED VOLTAGE.
9

INSTALLATION

The generator in question must be supplied with a rated
voltage of 1x230V~±15%/50-60Hz
Connect the generator to the mains supply and position
the switch to the "I"/"ON" position, and the welding
machine will set itself into the last welding process used.
Using the front panel, choose the new welding process.
MASTERWELD 200 AC/DC
IG
welding with pulsed current at
) (Only TIG DC)
T
) (Only TIG DC)
T
H )
T F
(4 H )
F T F
Bi-level (B )
F ILEVEL
.
10

REAR PANEL

OW
Fig. 4
• C1:Supply cable 3x2,5mm² with a length of 2,5m.
• A1:Rear gas connector. It is used to connect the gas
pipe coming from the gas bottle.
• I1: Supply switch. It is the switch to turn on the
machine. It has two positions, "I" and "O". When the
machine is connected to the mains with I1 in the "I"
position and in the MMA mode there is power between
the negative and positive clamps.
• Z1: Connector to power the cooling unit. If it is not
connected, continue to keep it closed with the cover
because there is an alternating 380V voltage!
11

FRONT OUTLETS

Fig. 5
• P1: NEGATIVE (-) welding socket.
• P2: POSITIVE (+) welding socket.
• A2: Front gas connector. It is used to connect the
gas pipe coming from the torch.
• J2: TIG torch. It is a five-pole AMPHENOL connector.
7
7
E n g l i s h
E n g l i s h