Hart HPHV34 Manual Del Operador página 5

OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 7.
Insert the battery pack into the battery port as shown.

Make sure the latch on the battery pack snaps into place

and the battery pack is secured in the product before
beginning operation.
Depress the latch and pull to release and remove the

battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
STARTING/STOPPING THE VACUUM
See Figure 2, page 7.
 To start the vacuum: press the ON/OFF button.
 To stop the vacuum: press the ON/OFF button.
INSTALLING ACCESSORIES/BEATER BAR
See Figure 3, page 7.
The following accessories are included:
Item
Crevice Tool ...........................542291001/542291002
Dust Brush .............................316959001/316959002
Beater Bar ..................................................... HPBB34
Install only accessories designed for use with this vacuum.
 Turn off the vacuum.
 Remove the battery pack.
 Place the accessory or beater bar into the port on the
nose of the vacuum.
 Push the accessory or beater bar securely into place.
 When not in use, remove and store the accessory.
MAINTENANCE
This product contains no serviceable parts.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
NOTE: Make sure the beater bar is fully inserted to engage
the motor. The roller bar should rotate when installed
properly.
For use with HPBB34 Beater Bar
REMOVING/REATTACHING THE DUST BOWL
See Figure 4, page 8.
The dust bowl should be checked, emptied, and cleaned
periodically for maximum dust collection.
To remove:
 Remove the battery pack.
 Depress the release button located on top of the hand
vac. Pull the dust bowl down and out.
To reattach:
 Position the two sections as shown. Align the slot on the
bottom of dust bowl with the tab on the bottom of motor
housing, then snap the two sections together.
INSTALLING WALL MOUNT
Part number
See Figure 5, page 8.
 Remove the battery pack.
 Secure wall mount with two screws and anchors (not
included).
NOTE: Make sure the wall mount is secure by finding a
stud or using wall anchors.
 With nose of vacuum pointing up slide the base on the
wall mount as shown for storage.
REMOVING THE ROLLER BRUSH FOR CLEANING
See Figures 6 - 7, page 8.
The roller brush is located inside the beater bar. The roller
brush has a tool-free end cap, allowing it to be easily
removed for cleaning.
To remove:
 Remove the battery pack.
 Rotate the end cap approximately 1/4 in. counterclockwise
to unlock the roller brush.
 Slide the brush to release the cap and pull the brush from
the beater bar assembly.
NOTE: Use scissors to remove any threads or hair
wrapped around the roller brush using the scissor
grooves.
5 – English