Hart HPHV34 Manual Del Operador página 6

MAINTENANCE
To reattach:
 Insert the roller brush into the beater bar assembly.
 Align the tabs on the cap to the notches on the assembly
and firmly press the cap into place.
NOTE: Make sure the opposite end of the roller brush is
aligned to the drive spindle when pressing the cap into
the assembly housing.
 Turn the end cap clockwise until it clicks into the locked
position.
CLEANING A JAMMED BRUSH ROLL
The brush roll is designed to stop spinning if it becomes
jammed with debris.
To reset:
 Turn hand vacuum OFF and remove the battery pack.
 Remove roller brush as described Removing the Roller
Brush for Cleaning.
 Inspect roller brush and its end caps for any obstructions.
Clear obstructions if present
 Reinstall the roller brush.
 After the motor has cooled for 30 seconds, reinstall the
battery pack to resume vacuuming.
NOTE: ILLUSTRATIONS START ON PAGE 7
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
CLEANING/REPLACING THE FILTER
See Figures 4 and 8, page 8.
 Remove the battery pack.
 Remove dust bowl from hand vac. Pull to remove filter
housing and filter from dust bowl.
 Turn the filter counterclockwise to remove from filter
housing. Turn clockwise to lock in place.
 Remove the filter from filter housing. Shake or lightly brush
any dust or dirt off the filter.
 Shake or lightly brush any dust off the filter housing. Wash
if necessary.
 Empty the dust bowl; wash if necessary. Before
reattaching to the hand vac, make sure all pieces are
completely dry.
NOTE: Allow 24 hours for parts to dry completely.
When purchasing replacement filter, request recommended
part number HAHV33.
6 – English