gs yuasa YCX 1.5 Guia Del Usuario página 8

Troubleshooting
Types of Indication
problems
Charger No indicator
does not lights on.
work.
Charger has LED fault
no DC indicator is ON.
output.
No charging LED fault
current. indicator is ON
and charging
percentage LED
bar flashing or
blinking in
sequence.
No charging LED fault
current. indicator is fast
flashing.
Full / float LED fault
light will not indicator is
come on flashing. The
or full LED charging
flashing. percentage LED
bar is flashing or
ON.
Maintenance
The charger is maintenance free. If the power cord is damaged, the charger must not be
used. The case should be cleaned occasionally. The charger should be disconnected from
the power while cleaning.
Possible Suggested solution
causes
No mains Check mains connections and
power. make sure power is switched ON.
Output is short Check DC connection between
circuited. charger and battery and make
sure they are not short circuiting.
Reverse
polarity Check that the crocodile clips
connection to have not fallen off the battery.
battery.
Check that the crocodile clips /
eyelets are connected to the
correct polarity.
Battery is Check the battery condition, age
severely etc.
sulphated.
Battery may need replacement.
Battery has a
damaged cell. Check the battery capacity.
Overheat Move battery and charger to
protection cooler environment.
mode.
Check the battery charger.
Battery Check the charger specification
capacity too matches the battery capacity.
large for the
battery charge Battery cannot be charged and
setting and it must be replaced.
has timed out
or battery is Charge rate selected might be too
slightly low. Switch charger off and on
sulphated.
and try a higher charge rate
setting, providing it doesn't
exceed the maximum charge limit
for your battery.
8