Publicidad
Step 9
Step
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (F) and lay it over your unit.
The BACK will be fl ush with the top edge and overhang
å
the bottom edge. Push on opposite corners of your unit if
needed to make it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the SHELF (E).
Fasten the TIE PLATES (3G) to the SKIRT (H) and
å
PLINTHS (R2). Use four BLACK 9/16" LARGE
HEAD SCREWS (1S).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
R2
3G
Page 14
These holes must line
up over the SHELF (E).
H
R2
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
This hole must be here.
BLACK 9/16" LARGE HEAD SCREW
(4 used for the TIE PLATES)
411861
1N
NAIL
(40 used in this step)
F
1S
www.sauder.com/services
Publicidad
