Grundig DSB 2000 Manual Del Usuario página 36

TROUBLESHOOTING _____________________
To keep the warranty valid, never try to repair the
system yourself. If you encounter problems when
using this unit, check the following points before
requesting service.
No power
• Ensure that the AC cord of the apparatus is
properly connected .
• Ensure that there is power at the AC outlet.
• Press standby button to turn the unit on.
Remote control does not work
• Before you press any playback control button,
first select the correct source.
• Reduce the distance between the remote con-
trol and the unit.
• Insert the battery with its polarities (+/-) alig-
ned as indicated.
• Replace the battery.
• Aim the remote control directly at the sensor
on the front of the unit.
No sound
• Make sure that the unit is not muted. Press
MUTE or VOL+/- button to resume normal lis-
tening.
• Press
on the unit or on the remote control to
switch the soundbar to standby mode. Then
press the button again to switch the sound-
bar on.
• Unplug both the soundbar and the subwoofer
from the mains socket, then plug them again.
Switch on the soundbar.
• Ensure the audio setting of the input source
(e.g. TV, game console, DVD player, etc.) is set
to PCM or Dolby Digital mode while using digi-
tal (e.g. HDMI, OPTICAL, COAXIAL) connection.
• The subwoofer is out of range, please move
the subwoofer closer to the soundbar. Make
sure the subwoofer is within 5 m of the sound-
bar (the closer the better).
36 ENGLISH
• The soundbar may have lost connection with
the subwoofer. Re-pair the units by following
the steps on the section "Pairing the Wireless
Subwoofer with the Soundbar".
• The unit may not be able to decode all digital
audio formats from the input source. In this
case, the unit will mute. This is NOT a defect.
device is not muted.
TV has display problem while viewing HDR
content from HDMI source.
• Some 4K HDR TVs require the HDMI input or
picture settings to be set for HDR content re-
ception. For further setup details on HDR dis-
play, please refer to the instruction manual of
your TV.
I can't find the Bluetooth name of this
unit on my Bluetooth device for Bluetooth
pairing
• Ensure the Bluetooth function is activated on
your Bluetooth device.
• Ensure you have paired the unit with your Blu-
etooth device.
This is a 15 mins power off function, one
of the ERPII standard requirement for
saving power
• When the unit's external input signal level is
too low, the unit will be turned off automatically
in 15 minutes. Please increase the volume
level of your external device.
The subwoofer is idle or the indicator of
subwoofer do not light up.
• Please unplug power cord from the mains so-
ckect, and plug it in again after 4 minutes to
resent the subwoofer.