Publicidad
Idiomas disponibles
Idiomas disponibles
8. Display Mode
When the device is switched on, shortly press the ON/OFF
button 1 to switch to another display mode to select your
desired display mode 9. There are 6 different display
modes. The default setting is mode 1.
9. Using the Lanyard
7
1. Thread the thinner end of the lanyard through the
hanging hole at the rear end of the device.
2. Thread the thicker end of the lanyard through the
threaded end before pulling it tightly.
®
10. Bluetooth
Function
This device can be used in conjunction with a smartphone
running the «Microlife Connected Health+» App. The
measurement results will be automatically transferred via
®
Bluetooth
.
Downloading the «Microlife Connected Health+» App
Download «Microlife Connected Health+» App for free from
Google Play™ (Android) or App Store (iOS) and install it on
your smartphone.
OXY 500 BT
®
How the Bluetooth
Function works
®
The Bluetooth
function on your device will automatically
turn on and will be ready to connect with the «Microlife
Connected Health+» App after the device is switched on.
Your device will automatically upload the data once it is
connected to the smartphone.
11. Malfunctions and Actions to take
Descrip-
Symptom/Possible
tion
causes
SpO
or
1. Finger is not
2
pulse rate
inserted
correctly.
do not
2. Patient SpO
display
2
value is too low to
normally.
be measured.
3. There is exces-
sive illumination.
SpO
or
1. Finger might not
2
pulse rate
be inserted deep
enough.
is shown
2. Excessive patient
unstable.
movement.
Descrip-
tion
The
device
cannot be
powered
on.
Solutions
The
1. Retry inserting the
display
finger.
suddenly
2. & 3. Measure more
switches
times. If you deter-
off.
mine the product is
working correctly,
consult your doctor.
1. Retry inserting the
finger.
12. Cleaning and Disinfecting
2. Sit calmly and retry.
Use an alcohol swab or cotton tissue moistened with
alcohol (70% Isopropyl) to clean the silicone that touches
the finger inside of the device. Also clean the finger being
Symptom/Possible
Solutions
causes
1. No batteries or
1. Replace the
low battery
batteries.
power.
2. Remove and rein-
2. Batteries are not
stall the batteries.
installed
3. Contact your local
correctly.
Microlife-Customer
3. The device may
Service.
be damaged.
1. The device is
1. Normal.
automatically
2. Replace the
powered off,
batteries.
when no signal
was detected
after 10±2
seconds.
2. The battery
power is too low
to operate.
5
EN
Publicidad
