Service And Maintenance - Festool UG-CSC-SYS Manual De Instrucciones

under­
frame
Bench
height
- High
working
position
- Low
working
position
Weight
Can be
loaded as a
work bench
up to
Can be
loaded as a
hand cart
up to
5 Parts of the device /
Functional description
[1-1] Feet locking lever
[1-2]
Additional feet
[1-3] Handle
[1-4]
Shovel locking lever
[1-5] Shovel
[1-6] Shovel protective feet
[1-7] Eyes for belt fastening
[1-8] plate
[1-9]
Foot height adjustment
The specified illustrations appear at the begin­
ning of the Operating Instructions.
6 Assembly
6.1 Fitting a handle [2]
Fit the handle before using for the first time
(see figure [2]).
7 Set-up/start-up
Keep the floor around the work bench level, in
good condition and free of loose objects (e.g.
chips and offcuts).
For the machine to stand securely on the plate,
always keep the plate free and clean.
UG-CSC-SYS
680 mm (26-25/32")
240 mm (9-15/32")
18.2 kg (40 lb)
100 kg (220.5 lb)
80 kg (176.4 lb)
7.1 Setting up in high working position [3]
► Offset slight unevenness in the stand area
with height adjustment [3-1].
The additional feet [3-2] serve to increase
stability with large or heavy workpieces.
7.2 Setting up in low working position [4]
See figure [4].
7.3 Setting up in hand cart position [5]
► Set up the protective feet to protect the
shovel's surface.
► Secure the load to be transported with the
belt, which is one of the items included. To
do so, guide the belt through the eyes [5-1]
provided.
7.4 Positioning the CSC SYS 50 EBI [6]
The plate of the underframe UG-CSC-SYS is
specially designed for the tool reception of
the CSC SYS 50 EBI. In each case,
the CSC SYS 50 EBI can be rotated by 30° until
the next secure tool reception.
7.5 Shovel as workpiece support [8]
The height of the work surface provided by
a CSC SYS 50 EBI placed on the underframe
matches that of a fully erected shovel. Longer
workpieces can be supported on the erected
shovel.
7.6 Putting down half-stationary
machines [7]
Other half-stationary machines must be put
down on the perforated top inside the marked
area [7-1].
8

Service and maintenance

Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.co.uk/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.co.uk/service
5
3
2
1
9 Environment
Do not dispose of the device in the
household waste! Recycle devices,
accessories and packaging. Observe
applicable national regulations.
Information on REACH:
reach
English
www.festool.co.uk/
11