Publicidad
Idiomas disponibles
Idiomas disponibles
EN
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-4.
1. ON/OFF switch
2. Rear hand position
3. Motor housing
4. Front handle
5. Spindle lock button
6. Angle adjustment knob
7. Fence
8. Height adjustment knob
9. Cutting depth adjustment knob
10. Depth fine adjustment screw
11. Base plate
12. Dust extraction adapter
13. Dust bag
14. Spanner
15. Centerline
16. Biscuit dowel
17. Flange nut
18. Saw blade
19. Flange
20. Bottom plate
21. Angle scale and arrow
22. Height scale and arrow
3. ASSEMBLY
Adjusting the cutting depth (Fig.B)
• Move the motor housing (3) as far as possible
backwards.
• Set the cutting depth by turning the cutting
depth adjustment knob (9).
• The markings on the depth adjustment knob (9)
correspond to the biscuit dowel size being used
(16).
• You can fine adjust the cutting depth setting by
turning the depth fine adjustment screw (10).
• Move the motor base forwards and check if
depth fine adjustment screw (10) will fall in the
notch of the adjustment knob.
The following table shows the relationship of the
markings on the adjustment knob to cutting depth,
thickness of material and associated biscuit dowel.
8
Marking
Thickness
of material
0
8-12 mm
10
12-15 mm
20
> 15 mm
Max.
-
Adjusting the cutting angle (Fig. A + G)
The cutting angle can be set the following way:
• Release the angle adjustment knob (6) by turn-
ing it anti-clockwise
• The set angle is shown on the scale (21) below
the knob (6)
• After setting to the right angle, tighten the knob
(6) again by turning it clockwise.
Adjusting the height to match material thickness
(Fig. B)
The correct height can be set the following way:
• Release the height adjustment knob (8) by
turning it anti-clockwise
• The set height is shown by the scale and the
arrow (22).
• After setting to the right height, tighten the
knob (8) again by turning it clockwise.
The height must correspond to half of the material
thickness of the working piece, the groove for the
biscuit dowel must always be in the middle of the
working piece.
Prior to mounting an accessory always
unplug the tool.
How to change the saw blade
Your machine is delivered with the saw
blade already assembled on the machine
Fig. C & D
• Put the machine in upside-down position and
remove the 4 screws on the bottom plate by
using a screw driver (not included)
• Remove the bottom plate (20)
• Press the spindle lock (5) and turn the spindle
until it engages in the lock. Keep the spindle
lock pressed during this procedure.
• Remove the flange nut (17) from the spindle
by using the spanner (14) and turn it counter-
clockwise.
Biscuit
Cutting
Dowel
depth
No. 0
8.0 mm
No. 10
10.0 mm
No. 20
12.3 mm
-
14.0 mm
WWW.VONROC.COM
Publicidad
