Descargar Imprimir esta página

CMT ORANGE TOOLS CMT9 Manual De Instrucciones página 7

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 12
14. Always lead the power supply cord away from the tool towards the rear.
15. Do not smear the tool base carelessly with thinner, gasoline, oil or the like.
They may cause cracks in the tool base
16. Draw attention to the need to use cutters of the correct shank diameter
and suitable for the speed of the tool.
17. Some material contains chemicals which may be toxic. Take caution to pre-
vent dust inhalation and skin contact. Follow material supplier safety data.
SAVE THESE INSTRUCTIONS
WARNING:
in this instruction manual may cause serious personal injury.
SYMBOLS
The following show the symbols used for the tool.
V ................. Voltage
A ................. Ampere
Hz ................. Hertz
n. ................. no load speed
-/min ............
/II .............. class II construction
Caution:
Always be sure that the tool is switched off and unplugged before carrying
out any work on this tool.
INSTALLING OR REMOVING THE TRIMMER BIT
Caution:
Do not tighten the collet nut without inserting a bit, or the collet cone will
break.
Depress the spindle lock, and use the spanner to tighten or release the bit.
Ensure the bit rotates freely once fit and spindle lock is released.
ADjUSTING THE DEPTH OF CUT (FIG.2)
2
www.cmtutensili.com
Misure or failure to follow the safety rules stated
revolutions or reciprocation per minute
Lock Lever
1. Loose the lock lever, place the cut-
ting cage's "
" mark direction rotate
unlock position, and slowly lower the
tool body until the cut bit just touches
the workpiece. Record the "A" data
at the time. Read just the tool body
until the desired depth of cut is ob-
tained and the scale data is "A + need
depth", finally rotate the cutting cage
"
" the point to the "LOCK" position
and tighten lock lever.
GB
7

Publicidad

loading