INVENTOR CB-WUI-20L Manual De Usuario página 22

• For drying clothes: place the dehumidifier in a small room and set nearby the
clothes rack. Keep doors shut and allow the dehumidifier to dry the clothes.
• For optimal results manual wringing of the clothes is suggested.
• Allow 30-50cm distance from the moist clothes.
• Thick and heavy fabrics may require more time for more effective results.
Cont.
Continuous mode: Press the mode button
panel and the Continuous dehumidification function will be selected.
Τhe dehumidifier operates continuously when the drainage pipe is attached, or until the water
tank is full, extracting humidity from the air. When this function is activated the indicator will
turn on and the device will work constantly, without the ability to select the desired humidity
levels.
This mode is suggested for special humidity conditions where big amounts of
condensation need to be extracted, such as extremely moist rooms.
Smart Dehumidification (SMD)
Smart Dehumidification (SMD): Press the mode button
on the control panel and the Smart dehumidification function will be selected. While operating
this mode the desired humidity levels cannot be adjusted.
CONTROL BUTTONS
Humidity Set Control Buttons
The humidity level can be set within a range of 35%RH (Relative Humidity) to
85%RH(Relative Humidity) in 5% increments each time one of the relative buttons
are pressed, as long as no other modes (Dryer, Cont. or Smart) are selected.
• For drier air press the descending arrow (˅) button to set a lower percent value (%)
• For damper air, press the ascending arrow (˄) pad to set a higher percent value.
22
When none of the above MODE functions are selected
(Dryer, Cont., Smart) and all indication lights are off
the desired humidity levels can be set manually by
pressing the (˄) (˅) buttons.
Up and down arrow buttons are inactive while Dryer
or Cont or Smart modes are selected
until the ''Cont.'' indicator will lit on the control
until the ''SMD'' indicator will lit
EN