Pan Detector - Kuppersbusch KI6870.0SR Instrucciones De Uso

EN
indicator*.
Decimal dot of power and/of
residual heat indicator.
function activated*.
function.
function activated*.
Timer indicator.
Decimal dot of the timer.*
function.
Activation sensor for "Flex
on model).
functions.
function activated*.
function activated*.
function activated*.
function activated*.
function activated*.
function activated*.
function activated*.
function activated*; (depending on
model).
activated*; (depending on model).
function* ; (depending on model).
Activation sensor for "Slide
function activated*; (depending on
model).
* Only visible while running.
The manoeuvres are done by means
of the touch keys. You do not need
to exert force on the desired touch
function
Use the cursor slider (2) to adjust
power levels (0 - 9) by sliding your
48
towards the left decreases it.
It's also possible to directly select a
power level by placing your finger
directly on a desired point of the cursor
slider (2)
In order to select a plate on
these models, directly touch the
cursor slider (2).
SWITCHING ON THE DEVICE
1 Touch the On touch key
least one second. The touch control
heard and the indicators (3) will light
If you do not take any action in the
next 10 seconds the touch control will
you can disconnect it at any time by
touching the touch button
if it has been locked (lock function
activated). The touch button
always has priority to disconnect the
touch control.
ACTIVATING PLATES
Once the Touch Control is activated
with sensor
turned on by following these steps:
1 Slide the finger or touch in any
position of one of the cursors
selected and simultaneuously the
power level will be set between 0
and 9. That power value will be
shown on the corresponding power
indicator and its decimal dot (4) will
keep light up during 10 seconds.
2 Use the cursor slider (2) to choose a
new cooking level between 0 and 9.
TURNING OFF A PLATE
Using the touch slider key (2) lower
the power to level 0. The hotplate will
H will appear in its power indicator
cooking area is hot and there is a risk
light up if the hob is still connected.
TURNING ALL PLATES OFF
All plates can be simultaneously
disconnected by using the general on/
(1) for at
(1). All plate indicators (3)

Pan detector

Make sure that the bottom of
the vessel, covers one or more of
the references (
Induction cooking zones have a built-in
stop working if there is no pan present
(1)
or if the pan is not suitable.
The power indicator (3) will show a
symbol to designate "there is no pan
detected or the pan is not suitable
stop supplying energy and it will
When a pan is once again placed
will resume at the same power level
previously selected.
The time for pan detection are 30
seconds. If a pan is not placed
cooking zone by using the touch
controls. Otherwise an undesired
operation could occur if a pan is
accidentally placed on the cooking
zone during the 30 seconds. Avoid
possible accidents!
)on the surface