Lithium­iOn Battery Status Display; Items Supplied - Hilti TE 500-A36 Manual De Instrucciones

3.4.1 MMI
Status
The Service indicator lights up.
The Service indicator flashes.
The ON/OFF indicator lights up.
The ON/OFF indicator flashes.
The ON/OFF indicator is off.
The Half power indicator lights up.
The Half power indicator is off.
3.4.2 Lithium­ion battery status display
The Li-ion battery state of charge and malfunctions of the power tool are
indicated by the display on the Li­ion battery. The Li­ion battery state of
charge is displayed after pressing one of the two battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
1 LED flashes, the product is not in
working order.
4 LEDs flash, the product is not in
working order.
Battery state of charge cannot be displayed while the control switch is
pressed and for up to 5 seconds after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given
in the Troubleshooting section.

3.5 Items supplied

Breaker, side handle, operating instructions.
Other system products approved for use with this product can be found at
your local Hilti Store or online at: www.hilti.group.
*2240496*
Meaning
Servicing is due.
Have the product repaired by Hilti
Service.
The product is switched on
The product is switched off be-
cause of a transient fault.
The product is switched off.
The product is working at half
power.
The product is working at full
power.
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
State of charge: 10 % to 25 %
State of charge: < 10 %
The battery has overheated or is
completely discharged.
The power tool is overloaded or has
overheated.
2240496 English 9