Unpacking Instruction; Power Supply; Replacing The Fuse; Backpanel - Vonyx VX Serie Manual De Instrucciones

UNPACKING INSTRUCTION

CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.

REPLACING THE FUSE

If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.

BACKPANEL

1. DISPLAY
2. BUTTON CLUSTER
PREVIOUS: Press to go back to previous track.
PLAY/PAUSE: Press to (re)start or pause play.
NEXT: Press to skip to next track.
MODE: Press to toggle between input modes.
3. USB PORT
You can play media files from a USB device by connecting the device
to this slot.
4. SD CARD SLOT
Insert an SD card in this slot.
5. MICROPHONE VOLUME CONTROL
Turn to adjust the microphone output volume.
6. MICROPHONE ECHO CONTROL
Turn to adjust the microphone echo effect.
7. TREBLE
Adjust the high tones (frequencies) of the corresponding channel.
8. BASS
Adjust the low tones (frequencies) of the corresponding channel.
9. SUB VOLUME
Turn to adjust the subwoofer output volume.
10. MASTER VOLUME
Turn to adjust the master volume.
11. MICROPHONE INPUT
6.3mm microphone jack input.
12. LINE INPUT
6.3mm line jack input.
13. INPUT SELECTOR SWITCH
Press to switch between line- & BT/MP3 input.
14. RCA LINE INPUT
RCA input connectors to receive AUX signal.
15. RCA LINE OUTPUT
RCA output to connect with input of another active speaker.
16. SPEAKER OUTPUT
NL4 output to connect with satellite speakers 1 & 2.
WARNING: connect only the supplied passive speaker on the speaker output terminal!
17. POWER SWITCH
Press to turn the device ON/OFF.
18. POWER IN AND FUSE HOLDER
Socket for plugging in the supplied power cord (top). For instructions on how to change the fuse (bottom), see "REPLACING
THE FUSE".