Jamara Mercedes-AMG GLC 63 S Coupe 4 WD Instrucciones página 8

GB
1. Mounting the wheels
Front wheels
Start by mounting the front wheels. Slide a washer onto the front axle and fit a wheel. Be careful
not to confuse the front and rear wheels. Inserting a washer from the outside and secured with a
clip. Mount the other wheel in the same way.
Rear wheels
Put the rear wheel on the rear axle. From the outside a washer is put on and secured with a clip.
Mount the other wheel in the same way. Press the wheel covers onto the front and rear wheels.
2. Mounting the steering wheel
First connect the plug on the dashboard cable to the black plug protruding from the front of the
chassis interior. Connect the cable in the steering wheel to the cable in the steering column.
Then slide the steering wheel (4) onto the handlebar and tighten it. The hole position is fixed by
a nut.
3. Mounting the doors
Fit the car doors by aligning them with the recesses and hinges in the bodywork. Then secure
the doors with 2 screws
4. Mounting the windshield
Move the windshield to the intended position. Drücken Sie die Zapfen in die
Nuten, bis sie einrasten.
5. Mounting the rear-view mirrors
Press the rearview mirrors into the intended positions on the car doors until they click into place
6. Battery connection
Connect all connectors as shown. Only connect plug connections that fit into each other and
take care not to reverse polarity. Make sure that the red cable (plus) and the black cable
(minus) are connected to the respective connectors of the same colour. Switch on the vehicle
by pressing the red button on the right side of the dashboard..
3
2
1
C
a
b
Functions
1 Soundboard
a USB
b Micro SD
c Line in
After inserting a Micro SD card or USB stick, the soundboard starts playing the tracks one after
the other. Only files with the extension .mp3 can be played back. It is not possible to fast-forward
or rewind.
2 Voltage display
Attention!
Your vehicle displays the total voltage of the two batteries in volts immediately after switching on.
The fully charged batteries will usually display a total voltage of approx. 12.6-13 volts unloaded.
The display is load dependent. This means that the displayed voltage will drop under load. If
a voltage of less than approx. 11.8V is displayed in the unloaded state, you should switch off
the Ride-on and charge the battery (see charging procedure). Otherwise the battery may be
deeply discharged and irretrievably damaged.
3 Simulated dashboard
4 Speed
High speed - Fast speed
Low speed - Slow speed
IMPORTANT!
The vehicle must be stationary before changing direction or speed. Otherwise the gear
unit and/or the motor could be damaged.
Problem
The battery can no longer be charged
The battery can no longer be charged although the battery and charger
are OK.
The journey time is very short.
No function
Can be switched on but does not drive.
Can be switched on but does notmove, or only direction.
Can be switched on but only travels in one direction
The active fuse blows and switches the unit off for a few seconds. You will
hear a single click at the beginning
No sound function on the steering wheel/andlebar
Vehicle has very high wear on switches.
The rubber tyres come loose on the wheels
8
4
6
5
7
8
Source
Carger or battery defective.
Charging socket defective
The battery has been deep discharged or is worn out.
Battery is not or incorrectly connected.
ON/OFF switch defective.
Motor cable incorrectly connected or not connected.
Gas or direction switch defective.
Directional switch defective.
Oberload or electrical short circuit.
the cable was torn or crushed during assembly.
Dirt and moisture damage the switches.
Ridden on too hot a surface or in dirt.
7. Mounting the seat
Insert the two pins at the rear end of the seat into the holes provided for this purpose.
Take two of the enclosed screws and fix the seat with them.
8. Charging
• The power swich must be turned in OFF position when charging.
• Insert the charger (13) into the socket - the LED lights up green. Connect the charger to
the charging socket.
• The LED on your charger lights up red as long as the battery is being charged. If the LED
lights green again, the battery is fully charged.
• The charge time is 9 hours.
• Do not charge the battery more than once within 24 hours.
• Charger and battery heat up during the charging process.
Warning!
The charger is not a toy. Only use the charger supplied.
•
The battery may only be charged by or under the supervision of an adult.
•
The terminals must not be short-circuited.
•
The charger must be checked regularly for damage to the cable, plug, housing and other
•
parts. If any damage is found, the charger must not be used until the damage has been
repaired.
• Let the model cool off sufficiently after each use before putting it back into operation.
When using an additional batteries let it cool off for minimum 15 minutes until the
model is operated again. Overheating can damage the electronics or may result in fire.
• Always disconnect the model from the charger immediately after charging. Always
disconnect the charger from the power supply immediately after disconnecting the
model. Inserting the rechargeable model or charger after charging will result in damage
tothe model, charger or the power supply (fire hazard).
• Use the charger only in dry rooms.
Important operating information:
In 1st gear the engine power is reduced and the rear wheels can turn at different speeds
depending on the load. This allows slower driving and, above all, a small turning circle. This also
means that in first gear, when starting off, or when driving over a small obstacle on one side, the
loaded wheel can stop and the driving force is transferred to the unloaded wheel. In order to
achieve full engine power and to distribute the driving force evenly over both wheels, it is
necessary to shift into 2nd gear. Attention! In 2nd gear not only the speed increases but also a
larger turning circle is achieved.
5 ON/Off switch
With the ON / OFF switch you start the vehicle. (Soft-start and soft-stop function)
6 2WD / 4WD switch
Switch from 2-wheel to all-wheel drive
7 Light button
8 Shift Lever
Forward: Press the "Forward-backward switch" on the "Forward" position.
Press the "Foot pedal", the model drives forward.
Reverse: Press the "Forward-backward switch" on the "Backward" position.
Press the "Foot pedal", the model drives backward.
IMPORTANT!
Always stop vehicle when changing the direction to avoid damage the gears and motor.
Otherwise the gear unit and/or the motor could be damaged.
Solution
Check charger and battery
Check or replace the charging socket.
Use a new battery and avoid deep discharge.
Connect the battery (see instructions)
Check or replace switch.
Check and connect motor cable (see instructions).
Check or replace switch.
Check or replace switch.
Do not overload or have the until checked.
Check or replace the steering wheel.
Do not drive in moisture or dirt such as meadows, gavel, sand, etc.
Change tyres and avoid hot surfaces and dirt.