Publicidad
GB
Note
The product is supplied with a wheel hub (2) inside the wheels. This wheel hub (2) could fall out
and end up in the cardboard box. If this is the case, put the wheel hub back into the wheel and
start assembly.
1. Mounting the front wheels
Attach the axle cap (15) to the front as shown in the picture and push the front axle (1)
through. Then push a front wheel (3) with the wheel hub (2) already fitted onto the front
axle (1). Then press a rim (4) onto the front wheel and secure it by first inserting a small axle
lock (5) and then a small axle cover (6) onto the end of the front axle (1). Repeat this
procedure on the other side.
2. Assembly of the rear wheels
Push the rear wheels (8) onto the rear axle (7) and press the rear rims (9) onto
the wheels until they engage. Secure the wheels by first placing the large axle
lock (10) and then the large axle cover (11) on the ends of the rear axle (7).
Repeat this procedure on the other side.
3. Assembly of the steering wheel
Place the steering wheel (12) on the steering wheel socket (13) and press the
steering wheel into the recess until it engages.
4. Assembly of the seat
Slide the seat (12) onto the corresponding rail of the mudguard (14).
And push it back until it is firmly seated.
7
7.1
Problem
The battery can no longer be charged
The battery can no longer be charged although the battery and charger
are OK.
The journey time is very short.
No function
Can be switched on but does not drive.
Can be switched on but does notmove, or only direction.
Can be switched on but only travels in one direction
The active fuse blows and switches the unit off for a few seconds. You will
hear a single click at the beginning
Vehicle has very high wear on switches.
The rubber tyres come loose on the wheels
8
5. Battery connection
Open the bonnet. Connect all connectors as shown. Only plug matching connectors into
eachother and be sure not to reverse the polarity. Make sure the red wire is well connected with
the red terminal on the battery, and same as the black one.
6. Charging Your Vehicle
● The POWER SWITCH must be turned in OFF position when charging.
● Connect the adapter cable (2) with the battery (1) and the charger (3)
● Plug the charger into the socket
● The charge time is 12 hours.
● Do not charge the battery more than once within 24 hours.
● Charger and battery heat up during the charging process.
● After the charging process you have to re-install the battery in your model, make sure that you
connect the battery correctly and do not reverse the polarity.
Warning!
The charger is not a toy. Only use the charger supplied.
•
The battery may only be charged by or under the supervision of an adult.
•
The terminals must not be short-circuited.
•
The charger must be checked regularly for damage to the cable, plug, housing and other
•
parts. If any damage is found, the charger must not be used until the damage has been
repaired.
• Let the model cool off sufficiently after each use before putting it back into operation.
When using an additional batteries let it cool off for minimum 15 minutes until the
model is operated again. Overheating can damage the electronics or may result in fire.
• Always disconnect the model from the charger immediately after charging. Always
disconnect the charger from the power supply immediately after disconnecting the
model. Inserting the rechargeable model or charger after charging will result in damage
tothe model, charger or the power supply (fire hazard).
• Use the charger only in dry rooms.
Starting the model
Press the key (7) into the ignition lock until the light (7.1) is illuminated.
Make sure to remove the key from the ignition after use, otherwise your battery could be deeply
discharged.
Forward / Reverse driving
Set the gear lever to the forward/reverse position.
Press the accelerator pedal to drive the model forwards and backwards.
Source
Carger or battery defective.
Charging socket defective
The battery has been deep discharged or is worn out.
Battery is not or incorrectly connected.
ON/OFF switch defective.
Motor cable incorrectly connected or not connected.
Gas or direction switch defective.
Directional switch defective.
Oberload or electrical short circuit.
Dirt and moisture damage the switches.
Ridden on too hot a surface or in dirt.
Solution
Check charger and battery
Check or replace the charging socket.
Use a new battery and avoid deep discharge.
Connect the battery (see instructions)
Check or replace switch.
Check and connect motor cable (see instructions).
Check or replace switch.
Check or replace switch.
Do not overload or have the until checked.
Do not drive in moisture or dirt such as meadows, gavel, sand, etc.
Change tyres and avoid hot surfaces and dirt.
Publicidad
