Getting Started; Step 1: Prepare Your Skin; Step 2: Device Operation - Sensica IPL300 Serie Manual Del Usuario

5. Wait 48 hours and
examine the tested area:
• If the skin in the test
area seems normal
(there is no reaction or
just a mild redness), you
can proceed with a full
treatment on the highest
comfortable energy
level that you tested.
Note: You may use the Energy
Recommendation button
to automatically detect
the recommended energy
level for each treatment
area. Please note this is a
recommendation based on
your skin tone and you are
recommended to test that this
energy is comfortable for you.

Getting Started

Step 1: Prepare your skin

1. Remove all jewelry.
2. Make sure the hair in the
treatment area is shaved
or trimmed (between
treatments you can
shave, but don't wax or
pluck hair), and that the
skin is free of any residue
from: powders, creams,
makeup, antiperspirants
or deodorants.
3. Never use flammable
liquids such as alcohol
(including perfumes,
sanitizers, or other
applications containing
alcohol) or acetone on the
skin for one hour before
using the device, as it may
cause burning of the skin.
Important: Do not use any
cream or gel while using the
device since it may prevent
normal operation.
Remember: The device is
equipped with a built-in
skin-tone sensor, allowing the
device to work only on suitable
skin tones. This unique safety
feature will prevent a flash from
occurring on specific areas
where your skin is too dark
or too tanned, even if your
general skin type is lighter.

Step 2: Device operation

Note: A preliminary test
should be conducted before
proceeding with a full
treatment. See "Preliminary
Test" section above. Make sure
the device is clean, dry and
intact. You can use the device
while it is being charged.
However, this may limit the
number of pulses since battery
charging is slower than battery
consumption during use.
13