Soundoff Signal P 7X3 Serie Instrucciones De Montaje

P SERIES 7X3 - STOP/TAIL & TURN LIGHTS
EPSSC0JY(x)-R - STT STUD MOUNT/SCREW MOUNT
EPSSC0JY(x)-A - AMBER TURN STUD MOUNT/SCREW MOUNT
7X3 STOP/TAIL LIGHT
WARNING
•HIGH CURRENT interconnects must be properly terminated. Poor crimp quality can cause heat build-up and fire. Follow crimp connector
manufacturer instructions.
•DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to vehicle Owner's Manual for deployment zones.
•Unit may become hot to touch during normal operation.
•Failure to properly install connectors, fuses or wiring may cause vehicle failure or fire.
•Installation must only be performed by trained technician. Installer must determine vehicle wiring configuration and proper integration of system.
•Use proper wire gauge. All power wires connecting to positive (+) or negative (-) battery terminal or local chassis ground (-) must be sized to
supply at least 125% of max. current and properly fused at power source.
•Install protective grommets when routing wire through firewall or metal.
1.800.338.7337 / www.soundoffsignal.com
1
Installers and users must comply with all applicable federal, state and local laws regarding use and installation of warning devices.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at www.soundoffsignal.com/tech-services/returns/.
If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. ET at 1.800.338.7337 (press #4).
Questions or comments that do not require immediate attention may be emailed to techservices@soundoffsignal.com.
NOTICE:
Improper use or installation may void warranty coverage.
E N H A N C I N G S A F E T Y T H R O U G H I N N O VAT I O N
P SERIES 7X3 STOP/TAIL LIGHT
TECHNICAL SPECIFICATIONS
Input Voltage: 9-32Vdc
STOP/TAIL LIGHT
CURRENT CONSUMPTION (Amps)
12.8Vdc 25.6Vdc
Peak
STOP 0.35
TAIL 0.04
TURN SIGNAL LIGHT
CURRENT CONSUMPTION (Amps)
12.8Vdc 25.6Vdc
Peak Average Peak
TURN 0.48 0.24 0.24
AFTER POWER IS ON, touching the WHITE wire to the
ground will allow you to change various settings on the
module. (refer to page 5).
NOTE: It is recommended to use the Stud Mount
option for any dynamic mount surfaces (i.e.
Swinging Panels, Doors, and Tail Gates).
WARNING
!
This product contains high intensity LED devices.
To prevent eye damage, DO NOT stare into the
light beam at close range.
Peak
0.18
0.02
Average
0.12
7X3 POLYCARB_STT 0122