Publicidad
Idiomas disponibles
Idiomas disponibles
WIRING AND TABLE INFORMATION
THERMAL COMPENSATION PROTECTION
The LED module is designed to provide maximum power output while providing protection to the electronic components by reducing the output power at extreme temperatures.
STOP/TAIL/TURN MODEL - WIRING DIRECTLY TO VEHICLE LIGHTING (Does not apply to bluePRINT
On some vehicles the 7X3 Stop and Turn models may not be compatible without additional wiring due to Pulse Width Modulation (PWM) on the vehicle's Stop, Turn, or Tail lamp circuits. The PWM cycling can cause
the lights to activate unintentionally when they are directly connected to the vehicle circuits. Using a BCM driven relay circuit such as the trailer circuit provided in most trucks allow for an isolated activation to the
lights. In cases where the vehicle does not have trailer circuits available, aftermarket relays may be used. Please see the schematics on Page 7.
STOP/TAIL LIGHT FUNCTION TABLE
WIRE
LIGHT
RED
ORANGE
WHITE
X
TAIL FUNCTION
X
STOP FUNCTION
STOP FUNCTION
X
X
(FLICKER PATTERN)
TURN LIGHT FUNCTION TABLE
WIRE
RED
ORANGE
WHITE
X
TAIL FUNCTION
X
TURN FUNCTION
NOTE: The inputs do not support PWM input signals.
ADVANCE PATTERN
Flash pattern can only be changed when the LED module is in a flashing mode (disabled in cruise or steady ON functions). When the light is flashing, momentarily connect the white wire to ground for >250mS and <1S (light will go
steady high) then release. The flash pattern will advance to the next pattern. If the light module was at the last pattern, the pattern will reset to the 1st pattern
TOGGLE MODE
Momentarily, connect the white wire to ground for >1S and <2S (light will go steady high, and steady low) then release. The output mode will toggle between "repeat sequence"
and "run sequence once" modes.
FACTORY RESET
Momentarily, connect the white wire to ground for >2S and <3S (light will go steady high, steady low, and off) then release. The LED module will reset to pattern 1 and mode "run
sequence once."
PROGRAMMING MODE NOTE: The light must be powered by the red or orange wire prior to activating the programming wire.
1.800.338.7337 / www.soundoffsignal.com
5
WIRE HOOK-UP TABLE
WIRE COLOR
RED
BLACK
GREEN
WHITE to POWER
ORANGE
LIGHT
Lights are chassis-grounded. If you need to ground-
switch the light, you must isolate the lights metal
backing, heatsink, studs and/or screws from the
body of the vehicle or use a relay.
Installations)
®
FUNCTION
Power (Stop/Turn Function)
Ground
Reserved - Factory Use
(Flicker Stop Pattern)
Power (Tail Function)
FOR THE TURN LIGHT ONLY
3
A FUSE
ORANGE
+Vdc
WHITE
Set-up/Function
RED
+Vdc
+Vdc
3
BLACK
A FUSE
FLASH PATTERNS
FLASHES PER
MINUTE
1
1 (Steady)
2
60
3
90
4
120
7X3 POLYCARB_STT 0122
Publicidad
