Publicidad
Idiomas disponibles
Idiomas disponibles
Step 6
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (40MA) to the ENDS (A and B). Use eight GOLD 5/16" FLAT HEAD SCREWS (3S) through
holes #1 and #4.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the ENDS. Turn a SCREW into this
hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
40MC
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(8 used for the RAILS)
1
Open end
www.sauder.com/service
3S
4
3
2
B
2
1
2
3
4
A
4
3
428397
40MA
Open end
1
1
2
3
4
7
Page 11
Publicidad
