Assembling; System Assembling; Connecting The Power Supply - Optika Italy ACCESSORIES Serie Manual De Instrucciones

8.

Assembling

8.1

System assembling

8.1.1 Installing adapter ring
1. Screw the adapter ring at the end of the microscope body.
(Fig. 1)
• The adapter ring has a groove ① for the connection of
the ringlight illuminator.
• In case of installation on SZP series the adapter ring
is not needed. The SZP objective has a groove for the
adaptation of the ringlight illuminator.
8.1.2 Installing the ringlight
1. Open the fixing knobs ② on the ringlight and fit the illuminator
on the adapter ring.
2. Screw the fixing knobs until the tips of the knobs enter into
the groove of the adapter ring. (Fig. 2)
• Only for CL-18: before installing the ringlight it is
mandatory to install the analyzer (see chapter 8.1.4).
8.1.3

Connecting the power supply

CL-16.1
1. Plug the power cord on the back of the control box. (Fig. 3).
CL-18
1. Plug the power supply on the side of the ringlight illuminator.
(Fig. 4).
①
②
②
Page 7
F ig. 1 F ig. 1
②
F ig. 2 F ig. 2
F F ig. 3 ig. 3
F ig. 4 F ig. 4