Transport And Installation; Operator Instructions - BM2 BIEMMEDUE BWK BAT Manual Del Usuario


Failure to observe the installation, use, operation,
service and repair instructions or performance of
these operations by unqualified personnel;

Use on unsuitable and incompatible surfaces.
3 Operation and technical specification
3.1 Operating the machine
The weed removal system is a professional machine for killing
weeds using hot water. It is intended to kill weeds using a jet of hot
water; all other uses not specified in this manual are considered
improper.
3.2 Intended conditions of use
The weed removal system has been designed for use exclusively as
described in this manual. It must be operated in environments
conforming to those described in the section on admissible
environmental values.
3.3 Noise
Refer to the machine's rating plate:
Values measured in compliance with ISO EN 3744.
3.4 Vibrations
The vibrations produced are minimal and do not represent a source
of danger for the operator.
No particular procedures must be adopted in order to
safeguard the operator from the effects of the vibrations
produced. In the event of abnormal vibrations, the operator
should immediately stop the machine and contact maintenance
personnel.
3.5 Degree of protection of the machines (IP)
Degree of protection against solid objects (protected
against dust)
Degree of protection against water (protected against
splashes of water)
3.6 Admissible environmental values
Admissible environmental values
Admissible operating
temperatures
Variations in ambient
temperature
Relative humidity range
Vibrations
The machine is not suitable for operating in environments at risk
from fire or explosion.
The machine cannot be used in environments with
explosive atmospheres.
5
4
-10°C - 50°C
(50° F - 113° F)
Max. 1.1°C / Min (Max 2°F /
Min)
75% or less
≤ 0.5 G

4 Transport and installation

4.1 Lifting and handling
IMPORTANT - Follow the instructions below.
The machine may be delivered from the Manufacturer on a pallet
and packed in a special cardboard box. Before unpacking, the
machine may be transported and handled by means of a lift truck
with a capacity higher than that of the packaged machine.
Straps
Box
To unpack the machine, remove the straps holding the cardboard
box to the pallet and remove the box. After the machine has been
unpacked, it must be lifted by passing lifting straps through the two
rear hooks. A number of safety instructions relating to transport are
given below.
The lifting and handling operations required for installation
must be performed using adequate lift equipment and by
specialist personnel trained to perform this type of operation,
adopting all the precautions necessary and recommended in
order to prevent damage to people or things.
4.2 INSTALLATION
IMPORTANT -
carefully read the warnings shown below. Failure to
observe the following warnings may cause injuries,
death or damage to the equipment.
5 Description
Below is a list of the contents of the package delivered to the
customer. If one of the parts listed below is missing, contact the
dealer immediately. To avoid loss during transport, the key is
enclosed in the bag with the technical documents.

1 x machine

1 x high pressure hose with M22 fittings

1 x handle

1 x lance with flat nozzle

1 x complete water coupling

1 x D4 hex key

1 x use and maintenance manual

6 Operator instructions

6.1 Safety instructions
1.
2.
3.
Pallet
Before installing the machine,