Publicidad
Idiomas disponibles
Idiomas disponibles
2
5
To start working, do as follows:
1. Carry out all the checks in the section
2. Insert the plug (1) of the power supply cable (2) in the mains
supply socket (3) (Fig.1).
3. Switch on the machine by positioning one of the three switches
(4) to the work position "I" (Fig. 2).
1
At the end of the work, and before carrying out any type of
maintenance, perform the following operations:
1. Do what is required to make sure the machine is in a safe
condition (see
MACHINE
SAFETY'").
2. Take the appliance to the designated place for emptying the
collection tank.
ATTENTION: the place designated for this operation must
comply
with
current
regulations.
3. Empty the collection tank (see the section
CLEANING THE COLLECTION
4. Remove the accessory from the extension, clean it with a damp
cloth.
ATTENTION: When it is completely dry insert it into the
accessories support on the rear of the collection tank
(optional accessory).
2
1
1
1
6
WORK
"PREPARING TO
WORK".
ON
ON
3
2
1
2
AT THE END OF THE WORK
environmental
protection
"CHECKING AND
BAG").
5
7
ATTENTION: to double or triple the vacuum capacity
progressively activate the other two switches.
4. Proceed with the vacuuming.
ATTENTION: "If, when working, the intensity of the vacuum
should drop, read the chapter
OPERATION".
4
5. Remove the female part of the extension from the male part,
clean it under running water.
ATTENTION: When it is completely dry insert it into the
accessories support on the rear of the collection tank
(optional accessory).
6. Remove the vacuum hose (1) (Fig.1) from the vacuum nozzle (2)
in the cover of the collection tank, clean it under running water.
ATTENTION: When it is completely dry insert it into the
accessories support on the rear of the collection tank
(optional accessory).
ATTENTION: park the appliance in an enclosed place, on a
flat surface; near the appliance there must be no
objects that could either damage it, or be damaged through
contact with it.
23
7
6
8
CONTROL AND
Publicidad
