Technical Information; Installation Considerations - Hansgrohe ShowerSelect 157431 Serie Instrucciones De Montaje / Manejo / Garantía

English

Technical Information

Water pressure
Recommended
Maximum
Hot water temp.
Recommended 120°-140° F (48° - 60° C)*
Maximum
Max. flow rate
@ 44 PSI (0.3 MPa)
Max. flow rate
@ 80 PSI (0.55 MPa)

Installation Considerations

• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation
• This trim is for use with iBox Universal Plus model
01850181 (not included).
• To prevent scald injury, the maximum output
temperature of the shower valve must be no
higher than 120°F (49°C). In Massachusetts,
the maximum output temperature can be no
higher than 112°F (44°C).
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
158°F (70° C)*
6.8 GPM (25.7 L/min)**
1.8 GPM (6.8 L/min)***
* Review and follow all applicable local plumbing
codes when setting the temperature on the water
heater.
** As configured at the factory, if permitted by plumbing
code. Review and follow all applicable local plumb-
ing codes.
*** A fter modification using the included flow control
device.
• This thermostatic mixing valve is for use with a
showerhead rated at 1.1 GPM (4.2 L/min) or
higher.
• This product includes a device to reduce the
total simultaneous flow of water in the shower
to 1.8 GPM (6.8 L/min) @ 80 PSI (0.55 Mpa)
as required by some plumbing codes. See the
instructions on page 24.
• When the flow control accessory is installed, this
valve cannot be used as a tub filler.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.