Oversteel TOMBAC Manual Del Usuario página 7

Connecting to Windows PC via USB cable
First, you need to download the X-360 driver and install it on your Windows PC. Connect the
controller to the Windows PC via a USB cable.
The four LEDs in the controller start to flash slowly for 2 seconds, and then the controller driver
is automatically installed to the PC, after connect, LED1 and LED4 will flash slowly always, the
controller can be used. Support for X-360 mode games,
The X-360 driver is available on the internet.
Note: With vibration function but without motion sensing function under X-360 mode wired
connection.
LED indication description
1. Four LEDs blinking quickly and circularly: This controller is searching for wireless devices to be
paired.
2. LED(s) solid bright: This controller is connecting to the console normally via wireless.
3. LED(s) blinking quickly: This controller battery voltage is lower than 3,6V; if the voltage is lower
than 3.4V, the controller will be shut off automatically and can't be powered on.
4. LED(s) blinking slowly: This controller is connecting to the console via USB cable; when this
controller is being charged via connecting to a charger, four LEDs are blinking slowly, and
simultaneously, the four LEDs will be off after fully charged.
Controller parameter reference
Operating voltage
Operating current
Static current
Vibrating current
USB input voltage/current
Available distance
Battery voltage/capacity
Battery power-on time
Charging time
Static time
The frequency bands
The frequency Power
Net weight
Dimension
DC 3.7V-4.2V
20-30mA
20-800A
50-150mA
DC 5.0V/500mA
≤10m
3.7V / 600mAh
Around 8 hours (fully charged)
Around 2-3 hours
Around 30 days
2402-2480MHz
2.405GHz-2.485GHz
191g
151*107*62mm
EN
7