Preparing For Installation - Balluff BTL7 Serie Manual De Instrucciones

BTL7-A/C/E/G5 _ _ -M _ _ _ _ -K(8)-NEX-SR32/K_ _ _
Micropulse Transducer - Rod Style
4
Installation and connection
4.1 Installation guidelines
Non-magnetizable material
Non-magnetizable material
Magnet
1) Min. Ø D2 = Minimum diameter of the bore (see Tab. 4-1)
Fig. 4-1: Installation in non-magnetizable material
Magnetizable material
If using magnetizable material, the transducer must be
protected against magnetic interference through suitable
measures (e.g. spacer ring made of non-magnetizable
material, a suitable distance from strong external magnetic
fields).
Magnet Spacer ring made of non-magnetizable
material
Magnet Spacer ring made of non-magnetizable
material
1) Min. Ø D2 = Minimum diameter of the bore (see Tab. 4-1)
Fig. 4-2: Installation in magnetizable material
Rod diameter
10.2 mm
8 mm
Tab. 4-1: Bore diameter if installed in a hydraulic cylinder
10 english
Bore diameter D2
At least 13 mm
At least 11 mm
4.2

Preparing for installation

Installation note: We recommend using non-
magnetizable material to mount the transducer and
magnet.
Horizontal assembly: For horizontal assembly with
nominal lengths > 500 mm, support the rod and tighten it
at the end if necessary (only possible with a diameter of
10.2 mm).
Hydraulic cylinder: If installed in a hydraulic cylinder,
ensure that the minimum value for the bore diameter of the
support piston is complied with (see Tab. 4-1).
Fitting bore: The mounting surface of the BTL housing
must make full contact with the supporting surface. A
suitable O-ring must completely seal the bore, i.e. the
countersink for the O-ring must be produced in
accordance with Figure 4-3.
Fig. 4-3: Fitting bore for installing the BTL with O-ring
Magnet: Various magnets are available for the BTL7
transducer (See Accessories on page 23).
Ignition protection
"ec" and "tb"
Fitting bore
Countersink for
O-ring 15.4×2.1