Maintenance Instructions - PNI AP800C Manual De Usuario

Note: From the factory, the system board is set to connect the NO photocell.
Therefore, keep the jumper in the NO position, as seen in the image above.
Opening device connection
If you do not want to use the remote control to control the gates, connect
the external gate actuator to the terminal 11, such as the access button, the
access keypad, etc.
Diagram example when connecting an access button:
Connect the access button to terminals 10 and 11. Terminals 12 and 13 are for
powering the access button.

Maintenance instructions

The rack and gear must always be kept clean, free of objects that could
»
become an obstacle in opening or closing the doors.
Lubricants all moving parts of the automation system once every 3
»
months.
If the control panel is powered by a backup battery, check the battery
»
monthly and replace it if necessary.
Periodically check the condition of cables and connections.
»
Make sure that no water enters the engine.
»
User manual 14