Descargar Imprimir esta página

Safety Information; User Manual - PNI AP800C Manual De Usuario

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 42
Warnings
For your safety and to obtain an automation system with a correct operation,
make sure that the following conditions are met:
The gate structure must be adequate for the automation system
»
Make sure that the gates move correctly and evenly, without friction,
»
along the entire length of their path
The wheels and rails of the gates must be in good condition, free of rust
»
and well greased
The gates must be able to open and close freely, without obstacles
»
It is recommended to install a gate stop for the open position
»
DO NOT weld when the bearing is on the bearing sets, because it does
»
not have perfect contact with the bearings and they get burr trying to
make the table.
DO NOT weld with the motor mounted, as the Mainboard will heat up
»
and the wiring on the board will fail.

Safety information

Do not replace components and accessories other than those included or
»
recommended by the manufacturer.
Before powering the system, make sure that all connections and cables
»
are in good condition.
Turn off the power when performing maintenance operations.
»
Avoid the water control panel to avoid short circuits.
»
Do not power the motor, control panel or other accessories directly to
»
the power source.
Do not pass through the gates when they open or close.
»
Keep the remote control in a safe place away from children.
»
Read all information and warnings in this manual carefully before putting
»
the system into operation.
During the installation of the automation system, take measures regarding
»
the safety of people and maintaining the integrity of the space in which
you work.
The system has an overvoltage protection function to prevent damage to
»
the device or injuries.
Install the automation system taking into account the weight, length and
»
3

User manual

Publicidad

loading