Manteinance And Cleaning; Stainless Steel - Infiniton CMPG-702 Manual De Instrucciones

Maintenance and cleaning
CAUTION! Before maintenance or cleaning is carried out, the cooker hood should be
disconnected from the mains power supply. Ensure that the cooker hood is switchedoff at the
wall socket and the plug removed.
Note External surfaces are susceptible to scratches andabrasions, so please follow the cleaning
instructionsto ensure the best possible result is achieved withoutdamage.
General
Cleaning and maintenance should be carried out withthe appliance cold especially when cleaning.
Avoid leaving alkaline or acid substances (lemonjuice, vinegar etc.) on the surfaces.

Stainless steel

The stainless steel must be cleaned regularly (e.g.weekly) to ensure a long life expectancy.Dry with a
clean soft cloth. A specialized stainlesssteel cleaning fluid may be used.
Note: Ensure that wiping is done along with thegrain of the stainless steel to prevent anyunsightly
crisscross scratching patterns fromappearing.
Control panel surface
The inlay control panel can be cleaned using warmsoapy water. Ensure the cloth is clean and well
wrungbefore cleaning. Use a dry soft cloth to remove anyexcess moisture left after cleaning.
Important! Using neutral detergents and avoid using harsh cleaning chemicals, stronghousehold
detergents or products containingabrasives,as this will affect the appearance of the appliance
and potentially remove any printingof artwork on the control panel and will voidmanufactures
warrantee.
Grease mesh filters
The mesh filters can be cleaned by hand.Soak them for about 3 minutes in water with a mild detergent
and then brush it gently with a soft brush. Do not apply too much pressure so as to avoid any damage to
it . (Leave to dry naturally out of direct sun light)
Filters should be washed separately to crockery andkitchen utensils.It is advisable not to use rinseaid.
Installing grease mesh filters
To install filters for the following four steps:
1. Angle the filter into the slots at the back of the hood.
2. Push the button on thehandle of the filter.
3. Release the handle once the filter fits into a resting position.
4. Repeat to install all filters.
9
English
infiniton.es