Publicidad
Idiomas disponibles
Idiomas disponibles
Restoring factory settings
7.4
Error codes and flashing sequences
Flashing code
Short orange flash-
ing
1x long green flash Transmission con-
1x long red flash
Short orange flash-
ing (every 10 s)
6x long red flashes Device defective
1x orange and 1x
green flash
8
Restoring factory settings
The device's factory settings can be restored. If you do this, you will
lose all your settings.
To restore the factory settings of the device, please proceed as follows:
•
Remove the rocker (if necessary).
•
Press and hold down the system button (A) for 4 s with a pointed
object (e.g. a pen) until the LED will start flashing orange quickly
(see figure 12).
•
Release the system button.
•
Press and hold down the system button again for 4 seconds, until
the LED lights up green (see figure 13).
•
Release the system button again to conclude the procedure.
38
Meaning
Radio transmission/
attempting to trans-
mit/data transmis-
sion
firmed
Transmission failed
or duty cycle limit is
reached
Pairing mode active Enter the last four numbers
Test display
Solution
Wait until the transmission is
completed.
You can continue operation.
Please try again (see „7.1
Command not confirmed"
on page 36 or see „7.2
Duty cycle" on page 37).
of the device serial num-
ber to confirm (see see „6.4
Pairing" on page 35).
Please see your app for er-
ror message or contact your
retailer.
You can continue once the
test display has stopped.
Publicidad
