EN /
If you want to reset the list of devices stored in the controller:
-Turn on the controller by holding down the Home button. Once it's turned on, release
the Home button.
-Press and hold the Home and Bluetooth® buttons for 5 seconds.
The controller will return to pairing mode and should appear in the list of devices
available for pairing.
I
Battery level indicator
You can see the battery's charge level at any time while using the product. To do this,
quickly double click on the Home button. The LEDs will toggle to indicate the battery's
charge level according to the sequence below:
- Battery full (100%): all 4 LEDs are lit
- Battery almost full (≥75%): 3 LEDs are lit
- Medium battery (≥50%): 2 LEDs are lit
- Low battery (≥25%): 1 LED is lit
- Very low battery (<25%): no LEDs light up
- Critically low battery (<10%): LED 1 will flash
I
Charging the controller
Take the USB-C cable provided and plug it into the socket on the bottom of the left
handle. Then plug the other end into one of the free USB ports on your PC or charger. The
LEDs will light up one by one to indicate charging.
Once all four LEDs are lit, your controller is fully charged.
I
Quickly changing the iPhone® connected to your controller
You can switch from one iPhone® to the previously connected iPhone® at any time
while using the product by quickly double-clicking the Bluetooth® button.
I
Product reset
If at any time during the use of the product you encounter difficulties with its operation,
you can shut down the controller.
To do this take a paper clip, or the tool for removing your SIM card from your phone,
insert it into the hole on the back of your controller and press the button. After pressing
the button, your controller will turn off and you will be able to turn it on again in the
normal way via the Home button.
I
Compatibility
The Nacon MG-X controller allows you to play on Microsoft's cloud gaming service. An
Xbox Game Pass subscription is required to access the gaming service.