Installation Instructions - arietta Urbino Guía De Instrucciones Para Instalación

Vertical Discharge
Use a rectangular 31⁄ " x 10" (8.3 x 25.4 cm) duct and transition or
4
use a 7" (17.8 cm) round transition for discharge of fumes to the
outside.
Preparation
Do not cut a joist or stud unless absolutely necessary. If a joist or
stud must be cut, then a supporting frame must be constructed.
Fittings material is provided to secure the hood to most types of
walls/ceilings.
However, a qualified technician must verify suitability of the
materials in accordance with the type of wall/ceiling.
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for exhaust vent.
I
CAUTION
For gas cooktop & range installations: Mount the hood so the
bottom is at least 30" (76.2 cm) above the cooking surface.
For electric/induction cooktop & range installations: Mount the
hood so the bottom is at least 24" (61 cm) above the cooking
surface.
There is no maximum mounting height, however, we recommend
mounting the hood no greater than 36" (91.4 cm) above the
cooking surface. For every inch (2.54 cm) above 36" (91.4 cm),
fume and moisture capture efficiency diminishes at an increasing
rate and may not deliver an acceptable level of ventilating
performance.
This hood is intended for household use.
PLEASE READ THE INSTALLATION MANUAL FOR SPECIFIC
APPLICATION. Check your ceiling height and hood height before
selecting your hood.

Installation instructions

Ducting version
After having choosen the vent option, proceed as follows:
1. Remove the grease filters.
I ATTENTION
If it is intended to use the hood in the recirculating version do not
remove any duct knockouts and order the necessary charcoal
filter from your supplier.
R1 = Remove rectangular duct knockout only.
R2 = Remove semicircular and rectangular duct knockouts.
R1
Rectangular
vertical discharge
For rectangular ducted discharge installations only.
1. Remove wrap from transition
2. Attach rectangular transition over knockout opening with 3 -
3.5 x 6.5 mm screws.
3. Make sure damper pivot is nearest to top/back edge of hood.
Remove tape from damper flap.
Pivot
5
R2
Round vertical
discharge
R1
Rectangular
horizontal discharge
Top/back edge
Exhaust transition/ damper