Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
When using the guide, avoid inclined cutting that
will allow the cut material to be caught between
the saw blade and the guide. Doing so may result
in injury.
Saw blade
Lumber
5. Sawing with a guide rail (sold separately)
(Fig. 22)
For dead straight, tear-free cutting edges with
millimeter precision. The anti-slip coating keeps the
surface safe and protects the workpiece against
scratches. See Accessories section. The rotary
button is used for setting a clearance-free fi t.
There are two guide grooves to place the machines
on guide tracks from diff erent manufacturers.
Rotary button
Mafell / Bosch
metabo HPT / Metabo /
Festool /Makita / Hilti
Guide
Fig. 21
Guide
grooves
Fig. 22
6. Setting extraction connector / dust ejection
The connector can be rotated to the desired position
to extract or eject sawdust. To do this, push the
connector in up to the stop, turn and pull out again.
The connector can thus be locked in 7 increments so
that it cannot turn.
<Sawdust extraction>
To extract the sawdust, connect a suitable extraction
unit with suction hose to the connector.
<Remove the connector>
Push the connector in up to the stop. Turn it so that it
is facing upwards. Remove and set to one side.
7. Adjusting the glass guard
Move the glass guard: top position for diagonal cuts,
central position for 0° cuts, bottom position when a
guide rail is used.
OPERATION
WARNING
● Pull out the battery after completing operation.
● Never touch the moving parts.
● Do not fi x and secure the lock-off button. Besides,
keep your fi nger off the trigger switch when the
power tool is being carried around. Otherwise,
the main body switch can be inadvertently
turned ON, resulting in unexpected accidents.
● Do not use any abrasive wheels.
● Use only blade diameter specifi ed on the product
nameplate.
● Should the saw blade be stopped or make an
abnormal noise during operation, turn off the
switch immediately.
CAUTION
● To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output. Therefore, if the tool is overloaded, the
motor may stop. However, this is not the trouble
but the result of protection function. In this case,
release the switch of tool and eliminate the
causes of overloading.
● Take care not to lock the motor. If the motor is
locked, immediately turn the power off . If the
motor is locked for a while, the motor or battery
may be burnt.
● Before use, check to see if the lock-off button
moves smoothly.
English
21
Publicidad
