Maintenance And Care - ACERBIS FLIP Manual De Instrucciones

EN
A - Once you are wearing the right size Acerbis helmet (closely following the
instructions above) firmly tighten the chinstrap by passing the end of the ribbon
through the "D" shaped rings. Now pass the end of the ribbon over one of the "D"
rings and through the second one (as shown in fig. A) then pull it until it is
comfortably stretched. To release the chinstrap, pull the red ribbon attached to one
of the "D" rings and remove the ribbon as shown in fig. A.
- Adjust the length of the chinstrap by sliding the ribbon through the buckle.
The fastened chinstrap must allow a finger to pass between the neck and the strap.
Clip the extra strap to the red button to prevent it from flapping while riding.
WARNING
The Red button is only intended to hold the excess part of the strap in place, it is
not a safety closure
B - To fasten the chinstrap, insert the auto lock male buckle into the corresponding
slot (see fig. B). Make sure that the buckle is fastened correctly by pulling the
chinstrap.
- Adjust the length of the chinstrap by sliding the ribbon through the buckle. When
the chinstrap is fastened, it must allow a finger to pass between the neck and the
ribbon, but it must not allow the helmet to slip o even if a great force is applied to
the back of the helmet.
To release the chinstrap, lift the red lever that fastens the auto lock male buckle.

5.0 MAINTENANCE AND CARE

Never clean your helmet with gasoline, thinners, glass cleaning solutions or products
containing alcohol. These agents could cause serious damage to the helmet, while
leaving no visible traces. In such cases, the helmet would no longer provide the
highest protection.
Helmet and shell
Only clean your helmet with lukewarm water (not hot!) and a few drops of mild soap
or with specific products, let the helmet dry at room temperature away from the sun
or heat sources.
Helmet and face shields ( inside and outside)
Use a mild solution of neutral soap and warm water for cleaning.
Never use boiling water, benzene salt, solvent or other aggressive agents.
Handle with care to avoid removing anti-scratch treatments and damaging it, when
scratches or any damage a ect visibility, replace it.
Helmet and inner padding, cap and cheek pads
Wash gently by hand and use neutral soap and water at 30° C. Rinse in warm water
and dry out of the sun.
Do not wash the inner components in the washing machine or dry them in the dryer
to avoid damaging the inner foam.
18