Titan TTB2700PRW Manual Del Usuario página 37

TTB2700PRW byTITAN
Problem
4. Strong
pressure
fluctuations
5. Water leakage
from product
6. Excessive
vibration/noise
7. No detergent
taken in
8. No water jet
96262_IM_TTB2700_4L.indb 37 96262_IM_TTB2700_4L.indb 37
Possible cause
4.1. Nozzle clogged
4.2. Water inlet volume is
too low
4.3. High-pressure hose is
leaking
4.4. Seals worn
4.5. Inlet water filter is dirty
4.6. Air being sucked into
the system
5.1. Seals worn
6.1. Screws and nuts
loosened
6.2. Motor problems
6.3. Water inlet volume is
too low
7.1. Soap tank not attached
7.2. Detergent too dense
7.3. Deposits or restriction
in detergent circuit
8.1. Trigger is not squeezed
8.2. Trigger lock is activated
8.3. No water supply
8.4. Inlet water filter is dirty
8.5. Hose blocked
8.6. Nozzle blocked
Troubleshooting
Solution
4.1. Clean the nozzle
4.2. Increase water inlet
quantity
4.3. Replace high-pressure
hose
4.4. Contact our nearest
authorised service
centre
4.5. Clean the filter
4.6. Check thickness of
hose fittings
5.1. Contact your nearest
authorised service
centre
6.1. Check screws and
nuts for tightness and
retighten as necessary
6.2. Contact your nearest
authorised service
centre
6.3. Increase water inlet
quantity
7.1. Attach the soap tank
7.2. Dilute with water
7.3. Flush with clean
water and eliminate
any restrictions. If
the problem persists,
contact an authorised
service centre
8.1. Squeeze the trigger
8.2. Deactivate the trigger
lock
8.3. Check water supply
8.4. Clean filter
8.5. Check hose
8.6. Check nozzle
EN
37
2021/9/16 下午5:07 2021/9/16 下午5:07