Publicidad
Idiomas disponibles
Idiomas disponibles
2. The wall mounting height of the heater shall be 180cm. As shown in the following figure, drill
two holes on the wall. Diameter and depth of the drilling hole are respectively 0.8cm and
3.5cm. The gap between the two drilling holes is 8cm. The distance between the drilling hole
and side wall shall be 20cm or longer.
3. As shown in the following figure, insert the plastic bulged plug into the drilling hole. The
product as shown by bracket screws into the wall of the expansion internal rotation.
4. Finally tighten the junction box lid screws up and then fixed, Products as below the
maximum elevation angle of 55 degrees.
Model
JA011855
Input Voltage
220-240V AC
-14-
Rated Input Power
1500W
Rated frequency(Hz)
50/60Hz
Publicidad
