Cembre B70M-P36 Manual De Uso Y De Mantenimiento página 17

4.3) Choosing the "release mode"
The phase of discharging the oil into the pump's tank can be carried out in two diff erent ways,
depending on the mode set in the menu:
Release
mode
SMART
factory setting
MANUAL
To change the "release mode" proceed as follows:
- Select screen 4 from the "main menu" (Ref. to § 4.1).
- Hold the finger on the button (4) until a confirmation "beep" is heard, the choice made is shown
by positioning of the cursor under the pictogram.
4.4) Choosing the "control mode"
The pump can be controlled during all working phases via the remote controller or via the button
(11) on the pump. Control mode selection is set in the menu:
Control
mode
REMOTE
CONTROLLER
factory setting
BUTTON
ERCH OFF
ON THE PUMP
To change the "release mode" proceed as follows:
- Select screen 5 from the "main menu" (Ref. to § 4.1).
- Hold the finger on the button (4) until a confirmation "beep" is heard.
17
Associated
pictogram
By releasing the start button the oil is returned in full to the pump
reservoir only following automatic shut-off of the motor. During
the return phase, pressing the buttons enables the head ram stroke
to be interrupted at any point so as to be able to restart from this
position in the next work phase, thus saving time and energy.
To return the oil to the pump reservoir it is necessary to press and
hold the release button.
During the return phase, by releasing the button it is possible for
head ram stroke to be interrupted at any point so as to be able
to restart from this position in the next work phase, thus saving
time and energy.
Associated
pictogram
The pump is controlled only by the remote controller, the push-
ERCH ON
button on the pump is disabled.
The remote controller is disabled, the pump is controlled only
via the push-button on the pump.
NOTE: After the pump is automatically turned off or the
battery is removed, the mode returns to the factory setting:
ERCH ON
Function
Function