Gescasi remock CODE Guia De Inicio Rapido página 12

SIMPLIFIED PROGRAMMING
Function description Operation
Enter programming mode
Change MASTER Code
IMPORTANT: Please remember the New
MASTER Code, as the default value cannot be
reset if forgotten.
Add fingerprint user
Add user PIN
Add user Card
Delete user
Exit programming mode
How to open the door
Fingerprint access
PIN access
Card Access
Close immediately: Press "0 #" on the device
Programming of the device with the Invisible Lock
Please kindly refer to the following steps to pair the device.
1: Enter programming mode
Remove the battery door of the invisible lock, Remock or Remock Pro, press the registration button
(round black button located to the left of the batteries) with a thin rod, hold it for 3 seconds until you
hear three beeps for the lock to enter programming mode.
2: Remock Code wireless panel programming
Press the "0" button and release it, then press and hold the "#" button for 2 seconds until the lock
beeps and the wireless panel is successfully programmed with the lock.
3: Exit programming mode
To finish, press the enrollment button on the invisible lock again until you hear a beep, or
wait for the enrollment period to end automatically (15 seconds). In either case you will hear
a beep to terminate the programming.
Simplified instruction
Operation
*(123456) #
(123456 is factory MASTER code)
0 (New Code) # (Repeat New Code) #
(Code: 6 digits)
1 (user ID)#(Put Fingerprint 3 times) #
1 (User ID) # (PIN) # or 1 (PIN) #
(PIN length: 4-6 digits)
1 (Zoom in Card) #
2 (Fingerprint) # or
2 (user ID) #
2 (PIN) #
2 (Card) #
*
(Place Fingerprint)
(PIN) #
# (Zoom in Card)