Before Startup; Water Supply - Kärcher K 6.91 M Manual Del Usuario

Illustrations on Page 4
1 Water connection
2 Fine filter in the water
connection
3 Coupling element for water connection
4 Quick coupling for high pressure hose
5 High pressure connection
6 Appliance switch "0/OFF"/ „I/ON"
7 Detergent Tank
8 Dosage regulator for detergent
9 Storage for trigger gun
10 Detergent suction hose (with sieve)
11 Transport handle
12 Storage for high-pressure hose
13 Storage for accessories
14 Mains cable with mains plug
15 Bearing wheel
16 Lock trigger gun
17 Trigger gun
18 Key to detach the high pressure hose
from the trigger gun
19 High pressure hose
20 Washing brush
21 Spray lance with Dirtblaster
22 Spray lance with pressure regulation
(Vario Power)
Special accessories
Special accessories expand the possibili-
ties of using your appliance. Please contact
your KÄRCHER dealer for further informa-
tion.

Before Startup

Mount loose parts delivered with appliance
prior to start-up.
Illustrations on fold-out
pages!
Illustration
 Insert the transport handle and screw
in.
 Insert holder for trigger gun.
Illustration
 Connect the suction hose for detergent
to the dosage regulator.
Illustration
 Lock the dosage regulator for detergent
into the cover.
Illustration
 Insert the cover and screw in.
Illustration
 Pull the suction hose for detergent
through the cover of the detergent tank
until the filter contacts teh bottom of the
tank.
Illustration
 Close the detergent tank with the lid.
 Lock the detergent tank in place on the
appliance.
Illustration
 Attach the accessories holder.
Illustration
 Fasten the quick coupling for the high
pressure hose to the high pressure con-
nection.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
 Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
 Screw the supplied coupling element to
the water connection on the appliance.
 Push the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
– 8
EN

Water supply

17