Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly (continued)
33
Installing fireplace insert
□
Lift the fireplace insert carefully into the back of the assembled mantel and centre it in the opening.
□
Using the pilot holes as a guide, fasten two L-shaped brackets (KK) onto the firebox holder (D1) with four pan head
screws (BB), Make sure that the right-angle side is flush with the short edge of firebox holder (D1).
□
Using the pilot holes as a guide, fasten the firebox holder (D1) between the partition panels (S and T) with four pan head screws (BB).
D1
BB
KK
D1
34
Installing tipping restraint hardware
WARNING: Young children can be seriously injured by tipping furniture. You must install the tipping restraint hardware
with the unit to prevent the unit from tipping, causing any accidents or damage. The tipping restraints are intended only
as a deterrent, they are not a substitute for proper adult supervision. The tipping restraints are not earthquake restraints. If
you wish to add the extra security of earthquake restraints, they must be purchased and installed separately.
□
With assistance, position the assembled fireplace at the desired location against a wall. If necessary, adjust the pre-
attached floor levelers by hand to correct tilting and level the doors, until the unit is level.
□
Follow the instructions printed on the plastic bag containing the tipping restraint hardware to attach the tip-over
restraints to the unit and the wall.
□
Connect the fireplace to the power transformer. Follow the operating manual for the electric fireplace insert to control
your fireplace.
K
U
K
U
S/T
D1
BB
Publicidad
