Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
Inspection and Receipt
Check the product upon receipt, after removing the equipment from its packaging, check the shipping documents
and check whether any damage has occurred to the equipment, caused by loading and transport. If any irregularity
has been found, such as lack of components or damage to the equipment, immediately notify the person responsible
for the transport and Sibrape.
Electrical Installation
The electrical installation must be carried out by a qualified professional and in accordance with current local
legislation and Technical Standards. For Brazil, the Technical Standard ABNT NBR 5410 - Low voltage electrical
installations, establishes in detail the criteria that must be followed for installation, protecting the installation,
equipment, people and animals.
A well dimensioned project guarantees a perfect functioning of the equipment, protects the equipment and
increases its useful life.
The power supply to the equipment must be done through an exclusive circuit, independent of the others.
Chlorine generators must be installed inside a machine room and with sufficient area for ventilation.
The equipment's power cables must be dimensioned by a qualified and qualified professional for this purpose.
CHECK THE CONNECTION VOLTAGE OF YOUR EQUIPMENT BEFORE CONNECTING POWER.
VERIFY THE CORRECT CONNECTION OF THE TERMINALS ON THE EQUIPMENT FOR THE AVAILABLE VOLTAGES
ACCORDING TO EACH PRODUCT.
It is mandatory to install devices that provide safety for the installation, equipment, people and animals, such as:
Contactor, Overload Relay, Surge Protection Devices, Phase Loss Relay, Residual Differential/Residual Differential
Switch and other necessary protections of according to the local standard.
The lack of electrical protection devices will result in the loss of the WARRANTY.
The warranty does not cover damage from electrical discharges, supply problems and natural phenomena.
Grounding: GROUNDING IS MANDATORY
For complete safety of the electrical installation, make sure that the motor is perfectly grounded, according to the
national technical standard. Use the existing terminal on the motor for grounding, connecting it to a wire of the
proper diameter as per the design and this wire to an appropriate iron/copper rod.
8
User's Guide
Publicidad
